|
POWER OUTPUT: 100 watts per channel
continuous from 20Hz to 20kHz. 1kHz total harmonic
distortion typically 0.5% at 100 watts, below .05% at 1
watt. Approximate actual power available at "clipping" 120
watts (1kHz). (Note that actual power output is dependent
upon both line voltage and "condition" i. e.: if power line
has high distortion, maximum power will be affected
adversely, although from a listening standpoint this is not
very critical.)
POWER BANDWIDTH: (-3dB points) 10Hz
to 40kHz.
FREQUENCY RESPONSE: (-3dB points at
1 watt) 0.8 Hz to 40 kHz.
INPUT SENSITIVITY: 1.1V RMS
Single-ended for rated output. (28dB gain into 8 ohms.)
|
|
INPUT IMPEDANCE: 100K ohms
Single-ended.
OUTPUT TAPS: 8 ohms, 4 ohms.
OUTPUT REGULATION: Approximately
0.9dB 8 ohm load to open circuit (Damping factor
approximately 11).
OVERALL NEGATIVE FEEDBACK: 12.7dB.
SLEW RATE: 6 volts/microsecond.
RISE TIME: 10 microseconds.
HUM & NOISE: Less than 0.2mV RMS -
103dB below rated output (IHF weighted, input shorted).
|
|
POWER SUPPLY ENERGY STORAGE:
Approximately 332 joules.
POWER REQUIREMENTS: 105-125VAC 60Hz
(210-250VAC 50Hz) 620 watts at rated output, 900 watts
maximum, 400 watts at "idle".
TUBES REQUIRED: 4 - Matched pair
6550C - Power Output; 5 - 6N1P input and driver.
DIMENSIONS : 17.5" (44.5 cm) W x
7.9" (20.1 cm) H x 19" (48.3 cm) D. Rear connectors extend
.88" beyond chassis.
WEIGHT: 61 lbs. (27.7 kg) Net; 69
lbs. (31.4 kg) Shipping.
Specifications subject to change
without notice. |
